Roller guide for the cabin
Roller guide for the cabin
Roller guide for the cabin Our roller guides GG and FK have been developed for counterweights and yoke guides as well as rope and hydraulic lifts. The roller block consists of a high-strength light metal alloy or steel. All wheels have an overrun Vulkollan® tread and branded ball bearings (INA, SKF, etc.). The standard hardnesses are 93 ° and 80 ° Shore A. Depending on requirements, the roller coverings can also be supplied with a hardness of 65 ° and 96 ° Shore A. Vulkollan® has a low rolling resistance, is quiet and vibration-damping, has the lowest setting behavior of all heavy-duty elastomers and excellent wear resistance. It is resistant to fats and oils. The rollers are infinitely adjustable via slotted holes with a sliding guide. In contrast to an eccentric alignment, the front rollers are thus always parallel to each other and can not be crushed. A permanent deformation of the roller lining (plates), a restless running and tension in the roller block are thus prevented. The front roller is adjusted via the slots in the roller block. The pitches for the attachment are chosen so that they can be easily exchanged with sliding guides WSMK, WSM, WSMKL and WSML. The guides are delivered pre-assembled. The mounting holes are chosen so that they can be easily exchanged with sliding guides WSMK, WSM, WSMKL and WSML. All rollers of the FK guides are equipped with 2 ball bearings to ensure an excellent concentricity in interaction with the over-turned roller covering. Special versions for higher loads are possible at any time.
Roller guide for the cabin Our roller guides GG and FK have been developed for counterweights and yoke guides as well as rope and hydraulic lifts. The roller block consists of a high-strength light metal alloy or steel. All wheels have an overrun Vulkollan® tread and branded ball bearings (INA, SKF, etc.). The standard hardnesses are 93 ° and 80 ° Shore A. Depending on requirements, the roller coverings can also be supplied with a hardness of 65 ° and 96 ° Shore A. Vulkollan® has a low rolling resistance, is quiet and vibration-damping, has the lowest setting behavior of all heavy-duty elastomers and excellent wear resistance. It is resistant to fats and oils. The rollers are infinitely adjustable via slotted holes with a sliding guide. In contrast to an eccentric alignment, the front rollers are thus always parallel to each other and can not be crushed. A permanent deformation of the roller lining (plates), a restless running and tension in the roller block are thus prevented. The front roller is adjusted via the slots in the roller block. The pitches for the attachment are chosen so that they can be easily exchanged with sliding guides WSMK, WSM, WSMKL and WSML. The guides are delivered pre-assembled. The mounting holes are chosen so that they can be easily exchanged with sliding guides WSMK, WSM, WSMKL and WSML. All rollers of the FK guides are equipped with 2 ball bearings to ensure an excellent concentricity in interaction with the over-turned roller covering. Special versions for higher loads are possible at any time.